Page 1 of 1
Waveform on a clear background?
Posted: Thu Jan 17, 2019 5:38 am
by terrypin
Is it possible to set up GoldWave so that,while recording, the waveform was displayed on a plain (black, white, green or blue) background please, i.e. without the grid.
I would capture that as a short video, import it into my video editor and make the background transparent, so that I could superimpose the waveform over an image or video.
Terry, East Grinstead, UK
Re: Waveform on a clear background?
Posted: Thu Jan 17, 2019 9:46 am
by terrypin
Just realised that removing the grid wouldn't work anyway, as GW does not display a dynamic waveform.
Re: Waveform on a clear background?
Posted: Mon Jan 28, 2019 9:48 am
by GoldWave Inc.
You can select the Waveform visual in the Control window. That is a realtime waveform displayed on a black background.
Re: Waveform on a clear background?
Posted: Wed Jan 30, 2019 5:54 am
by terrypin
GoldWave Inc. wrote:You can select the Waveform visual in the Control window. That is a realtime waveform displayed on a black background.
Thanks!
I assume I cannot remove the unwanted lower display? Best I can do so far is to make it blank.
Terry, East Grinstead, UK
Re: Waveform on a clear background?
Posted: Mon Feb 04, 2019 3:40 pm
by GoldWave Inc.
You should be able to use the video editing software to crop the capture so that only the waveform is shown. You can resize the Control window in GoldWave to make the visuals as large as possible.